Description:
The MKR IoT Bundle is a great way to get started with the Internet of Things and includes all the components you need to make 5 IoT projects following the step-by-step online tutorials on the Arduino Project Hub online platform.
SPECIFICATIONS :
-
-Microcontroller SAMD21 Cortex-M0+ 32bit low power ARM MCU
-
-Board Power Supply (USB/VIN) 5V
-
-Supported Battery(*) Li-Po single cell, 3.7V, 700mAh minimum
-
-Circuit Operating Voltage 3.3V
-
-Digital I/O Pins 8
-
-PWM Pins 12 (0, 1, 2, 3, 4, 5, 6, 7, 8, 10, A3 – or 18 -, A4 -or 19)
-
-UART 1
-
-SPI 1
-
-I2C 1
-
-Analog Input Pins 7 (ADC 8/10/12 bit)
-
-Analog Output Pins 1 (DAC 10 bit)
-
-External Interrupts 8 (0, 1, 4, 5, 6, 7, 8, A1 -or 16-, A2 – or 17)
-
-DC Current per I/O Pin 7 mA
-
-Flash Memory 256 KB
-
-SRAM 32 KB
-
-EEPROM no
-
-Clock Speed 32.768 kHz (RTC), 48 MHz
-
-LED_BUILTIN 6
-
-Full-Speed USB Device and embedded Host
-
-LED_BUILTIN 6
-
-Length 61.5 mm
-
-Width 25 mm
-
-Weight 32 gr.
-
KIT INCLUDES:
-
Each bundle includes:
-
1 Arduino MKR1000 board, with header soldered.
-
1 micro USB cable,
-
1 400-point breadboard,
-
70 solid-core jumper wires,
-
1 9V battery snap,
-
1 stranded jumper wire
-
1 stranded jumper wire,
-
6 phototransistors,
-
3 potentiometers (10 kilohm),
-
10 pushbuttons,
-
1 temperature sensor (TMP36),
-
1 tilt sensor,
-
1 alphanumeric LCD (16 x 2 characters),
-
1 bright white,
-
34 LEDs (1 bright white, 1 RGB, 8 red, 8 green, 8 yellow, 3 blue),
-
1 small DC motor (6/9V),
-
1 small servo motor,
-
1 piezo capsule (PKM17EPP-4001-B0),
-
1 H-bridge motor driver (L293D),
-
1 octocouplers (4NE5),
-
2 MOSFET transistors (IRF520),
-
5 capacitors (100uF),
-
5 diodes (1N4007),
-
3 transparent gels (R,G,B)
-
1 male pin strip (40 x 1),
-
20 resistors (220 ohm),
-
5 resistors (560 ohm),
-
5 resistors (1 kilohm),
-
5 resistors (4.7 kilohm),
-
20 resistors (10 kilohm),
-
5 resistors (1 megohm),
-
5 resistors (10 megohm)
Reviews
Clear filtersThere are no reviews yet.